Top and bottom tenons are recommended to be screwed into both posts at the top and bottom of each. Once the posts are fastened to the deck, you’ll need to fasten the tenons of the railing into the posts using the same application as the spindles are screwed to the rail. Once the post is firmly lagged into place, repeat this step with the second post. You can use a standard 6” length, 3/8 lag bolt with a 9/16 head and a washer to fasten the post to the deck. Now, it’s time to fasten your post to the deck. Be careful not to drill completely through the wood, so your lag bit holds onto the edge of the post. Then, make your mark at 3.25” and drill a hole. Turn the post 90 degrees-if using one fastener, your hole should be centrally located, or if using two fasteners, split the difference of the two. Once the two holes have been drilled for the railing, you’ll need to drill the end, so it can be fastened onto the deck. Use a half drill bit to drill holes in the two marks made in step 4. Use your torpedo level on the notch to ensure that these holes will be drilled in a straight line. Placing your measuring tape on the first mark, make your second mark at 30.74”.Īt this point, look up from the center of your notch and transpose that mark to the two marks you just made. Make your first mark at 5.25” from the bottom. Now that you have notched the line, corner, or inside post, it’s time to measure where you will drill for the tenon ends on the railing section. Be sure to remove all debris from the notch, so when fastening, you get a tight, secure fit. When making this notch, ensure that your log is parallel to the table, so when it mounts onto your deck, it’s straight. This will be the start of your notch, where you will now cut through, down to where the center was taken out with the chainsaw (or cross-cut saw). Once the cut is pushed all the way through, take it to a chop saw to cut the tail off the outside. Before cutting the post, ensure that it is secured using a trough stand or a sawhorse with a clamp. Some people prefer to use a cross-cut saw to cut the post, or, as in the video, you can use a chainsaw. There are two ways you can cut the post, depending on your personal preference. Then, transpose that mark up to the overhang mark that you previously made. Using a torpedo level, make a mark down the center of the post to ensure a straight line and cut. Make another mark on the other side at the same height. This mark will tell you how deep your lap will be hanging out. Next, measure the length to determine and mark where you would like the tail to hang over. Take that post and measure the width to find and mark the center point. Measure the Postįirst, locate what kind of post you need, such as an outside corner, inside corner, line post, or lap post. 6” length, 3/8 lag bolt with a 9/16 headħ Steps for Installing Log Railing Posts 1.To drill and install your log railing posts, you’ll need to first gather the following and materials: TOOLS AND MATERIALS: WHAT YOU’LL NEED For a DIY Log RailingĭIY log railing installation is simple as long as you follow the right steps. Here’s what you need to know before installing your log railing. In this blog, you’ll find tips on how to install railing posts. For the DIY-type, installing railing posts yourself may be the better option. We can even help with the log railing installation if you’d like. At Northern Log Supply, our railing is milled for easy installation and will arrive at your site ready to be installed. Cedar log railing can give your porch, deck, or staircase the rustic look and durability you desire for your log home or cabin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |